
.gif)
Hutton Close, Crowther Ind Est, Washington, Tyne & Wear NE38 0AH, England
Email: enquiry@isocomoptocouplers.com
- Tel: +44 (0)191 4166546 - Fax: +44 (0)191 4155055
Features
Description
Absolute Maximum
Ratings
Dimensions
Similar
Optocouplers
Home Page
Normally Closed, Normally Open, or Normally Closed and Open Circuits with
Single Pole Single Throw
Control 350 or 400 Vac or Vdc
Switch 130 mA
Loads
LED Control Current 2 mA
Low ON-Resistance
dv/dt >500 V/ms
Isolation
Test Voltage 1500 or 3750 Vrms(ac)
UL, CSA, FCC Compatible
The coupler consists of an AlGaAs LED that is optically coupled to a dielectrically isolated photodiode array which drives two series connected high voltage MOS transistors. The typical ON-Resistances (see table) of 20 or 40 ohms at 25mA are linear up to 50 mA; the incremental resistance drops to less than 20 to 40 ohms beyond 50 mA while reducing internal power dissipation at high load currents.
Telecommuncations - Telecom Switching; Tip/Ring Circuits; Modem Switching
(Laptop, Notebook, Pocket Size); Hookswitch; Dial Pulsing; Ground Start; Ringer
Injection
Instrumentation - Multiplexers; Data Acquisition; Electronic
Switching; I/O Subsystems; Meters (Watt-Hour, Water, Gas); Medical Equipment
Miscellaneous
- High Voltage Test Equipment; Triac Driver; Motor Control; Security; Aerospace;
Industrial Controls
Absolute Maximum Ratings: (Ta=25°C) | |
| Isolation Test Voltage: Isolation Resistance: Total Power Dissipation: Storage Temperature: Operating Temperature: Junction Temperature: Lead Soldering: |
1500 or 3750 Vrms (see Table below) >= 10 Gohm (Vio=500V,Ta=25°C) 550mW (derate 2.5mW/°C linearly from 25°C) -40°C to +150°C -40°C to +85°C 100°C 260°C for 10s, 2mm from case |
Input Emitter | |
| Reverse Voltage: Operation Input Current: Continuous Forward Current: Peak Forward Current (1s): Recovery Input Current: Forward Voltage: Power Dissipation: Derate Linearly above 25°C: |
5.0V 5mA 5mA-50mA 1A 0.2mA (ISX200S, ISX250S: 0.4mA) 2.0V (ISX200S, ISX250S: 1.8V) 100mW 1.3mW/°C (ISR100S: 3mW/°C) |
Output Detector | |
| Output Breakdown Voltage: Continuous Load Current: Load Type: Surge Load Current: Off-State Leakage Current, Max: Power Dissipation: |
±350V or ±400V (see Table below) ±130mA AC/DC 300mA 1µA 500mW |
Part Name: Parts ending 'S' are SOP (Small Package); other parts add 'A' for
Surface Mount
Abbreviations: NO - Normally Open; NC - Normally Closed
Units: mm; Tolerance: ±0.1 mm
| Package | SOP | DIL & Surface Mount | |||
|---|---|---|---|---|---|
| Pins | 4 | 6 | 8 | 6 | 8 |
| b | 4.4 | 6.5 | |||
| c | 13 degrees | ||||
| d | 2.54 | 2.54 | |||
| f | 3.4 | ||||
| g | 0.10 | 0.4 | |||
| h | 2.15 | 3.5 | |||
| k | 0.4 | 0.5 (DIL), 1.2 (SM) | |||
| l | 4.7 | 6.7 | 9.8 | 7.3 | 9.68 |
| s | 5.49 | 7.62 | |||
| t | 0.5 | 1.0 | |||
| v | 1.2 | ||||
| w | 6.8±0.4 | 10.0±0.4 | |||
| x | 0.15±0.03 | 0.254±0.05 | |||
Isocom takes great effort to ensure accurate data, but regrettably cannot be held liable for any error on its website. Visit File Lists to confirm old printouts are up-to-date.